Skip to content

Guide · Structural & Civil

Data Centers Are Reshaping Mesa — and Structural Engineering With Them

Mesa has become one of the busiest data center markets in the country. Here’s what structural and civil engineering for these buildings actually involves — and why the details matter more than the shell.

By Russell S. Johnson P.E. · Civil & Structural Engineering

Drive around Mesa and the East Valley and it’s hard to miss: data centers. Hyperscale campuses, colocation facilities, and the power and utility infrastructure to feed them have turned this part of the Valley into one of the fastest-growing data center markets in the country. For a civil and structural engineer who’s worked in Arizona for decades, it’s a striking change — and a demanding kind of project.

People picture a data center as a big, simple box. Structurally, it’s anything but. Here’s what actually goes into engineering one, and why the details matter more than the building shell.

A data center is a machine building

The structure exists to carry and protect equipment that has to keep running. That changes the design brief. You’re not just designing a roof and walls — you’re designing for heavy, concentrated equipment loads, vibration-sensitive systems, and a building that has to stay operational through events that would close an ordinary commercial building.

Loads that aren’t like other buildings

  • Heavy, concentrated equipment. Generators, switchgear, UPS systems, batteries, cooling equipment, and racks put large point loads exactly where the structure has to carry them — often on elevated floors and roofs.
  • Vibration. Sensitive equipment and the people maintaining it are affected by vibration. Floor systems and equipment supports sometimes have to be tuned, not just sized.
  • Anchorage. Equipment has to be anchored against wind and seismic forces. In this region seismic demands are moderate compared to the West Coast, but data centers are typically designed to a higher importance category — so the anchorage and detailing are more rigorous than the seismicity alone would suggest.
  • Redundancy. Tier III and Tier IV facilities are designed so systems keep running when something fails — which shows up structurally as redundant load paths and careful coordination with MEP.

Seismic and wind: importance changes the answer

Arizona isn’t California, and people sometimes assume that means seismic design is a formality here. For an ordinary building it’s often modest. For a data center it’s different: these facilities are usually assigned a high importance factor because of what they do, and that raises the design forces and the detailing requirements. Wind matters too — it drives the design of exterior equipment enclosures, generator yards, and roof-mounted systems.

The civil side is just as demanding

On the site side, a data center is a utility project as much as a building project. Grading and drainage have to handle large impervious areas and monsoon flows. The site has to accommodate heavy equipment access, generator yards, cooling infrastructure, and the buried utilities and conduit that feed the building. Power and water availability increasingly shape what can be built and where — and that’s a site-planning question before it’s a structural one.

Schedule is a design constraint

Data centers are built fast, and the structural design has to support that. That usually means early steel packages, tight coordination between structure and MEP so equipment fits and is supported, and detailing that fabricators and erectors can build without surprises. Structural engineering on these projects is as much about coordination and constructability as it is about calculations.

Frequently asked questions

What owners and developers ask most:

Do data centers need special structural engineering?
Yes. Heavy concentrated equipment loads, vibration, anchorage, redundancy, and a higher importance category all push the structural design beyond a typical warehouse or office building. The shell may look simple; the engineering behind it isn’t.
Is seismic design a big deal in Arizona?
Less than on the West Coast, but not negligible — and for a data center, the higher importance factor raises the design forces and detailing requirements. It’s a real part of the design, not a formality.
What does the civil engineer do on a data center project?
Site layout, grading and drainage for large impervious areas, stormwater management for monsoon flows, access and circulation for heavy equipment, and coordination of the utilities and infrastructure the facility depends on.
Can one firm handle both the site and the structure?
That’s an advantage on projects like this. The building, the equipment, and the site have to work together, and having civil and structural under one roof avoids the gaps that show up when they’re designed separately.
Why is Mesa such a focus?
Land, power, fiber, and proximity to the Phoenix metro have made the East Valley one of the country’s busiest data center markets. That concentration is why structural and civil engineers here are seeing so much of this work.

← All guides

Start a project

Need Civil Or Structural Engineering Support?

Speak with Russell S. Johnson P.E. about your next project in Mesa, Phoenix, and across Arizona.