Solar is close to standard equipment on Arizona roofs now, and home batteries are following fast. Most of the conversation is about production, incentives, and electrical design. The part that gets less attention is the roof underneath — and whether it can safely carry what’s being added to it.
The honest answer is that most modern roofs handle a standard solar array without drama. But “most” isn’t “all,” and the cases where it matters are exactly the ones that lead to leaks, sagging, or a failed inspection. Here’s how I’d think about it.
What solar actually adds to a roof
A typical residential PV array adds a few pounds per square foot of dead load — usually in the range of three to five psf for the panels, racking, and attachments. That sounds small, and on a sound modern roof it usually is. The load that governs the design, though, often isn’t the weight. It’s wind.
Wind, not weight, is usually the question in Arizona
Basic wind speeds in the Valley are in the range of about 105 to 115 mph depending on location. Panels and racking create uplift, and the attachments have to resist it. On a tile roof, or an older roof, or one with less-than-clear framing, that’s where an engineer gets involved — not because the panels are heavy, but because the connection has to hold.
When a structural review is worth it
- Older homes, or roofs that were hand-framed or never engineered. If nobody can tell you what the roof was designed for, it’s worth finding out.
- Tile roofs. The weight and the attachment detailing are both more involved than on a shingle roof.
- Large arrays, ballasted systems, or anything adding significant concentrated load.
- Adding a home battery. A wall-mounted battery is a heavy, concentrated load on a wall or floor — and it needs to be anchored, not just hung.
- Any project where the jurisdiction requires a PE letter or sealed calculations.
Home batteries are a structural question too
Battery storage is the newer piece of this, and it’s where I see the most overlooked issues. A home battery is a heavy unit mounted to a wall or set on a floor, and it has to be anchored for wind and seismic forces — and located where code allows, which usually excludes sleeping rooms and has limits on how much can be installed in a given space. That’s a structural and code question as much as an electrical one.
Permitting varies by city — a lot
Arizona doesn’t have a single statewide building code; each jurisdiction adopts and amends its own edition. That means the requirements for solar and storage — and whether a structural letter is needed — can differ from one city to the next, even within the Valley. Some jurisdictions have streamlined solar permitting; others want sealed structural calculations for roof-mounted systems.
What a structural review actually involves
Usually it’s a focused piece of work: we review the roof framing and the proposed array or battery layout, check the loads and the attachments, and either confirm the roof is adequate or identify what needs reinforcement. The deliverable is typically a short stamped letter or calculation set you can submit with the permit.
Frequently asked questions
The questions homeowners and installers ask most:
- Do I always need a structural engineer for solar?
- No. Standard arrays on sound, modern, engineered roofs often proceed under a streamlined permit without a separate structural letter. The cases that need review are older roofs, tile roofs, large or ballasted systems, and anything where the jurisdiction asks for sealed calculations.
- How much weight do solar panels add?
- Typically a few pounds per square foot — often around three to five psf including racking and attachments. It’s usually modest. Wind uplift on the attachments is often the governing concern, not the dead weight.
- Does a home battery need structural review?
- It can. A battery is a heavy, concentrated load that has to be anchored and located per code. Whether you need a formal review depends on the wall or floor it’s mounted to and the jurisdiction’s requirements.
- Why does the answer change from city to city?
- Because Arizona has no single statewide building code. Each city and county adopts its own edition and amendments, so solar and storage requirements — including structural submittals — vary by jurisdiction.
- Can the solar installer handle the structural side?
- Some can, and some jurisdictions accept manufacturer or installer documentation for standard systems. Where engineered review is required, that has to come from a licensed engineer.